I still use my Release 3 version but cannot load on my new machines as require 64 bit version. Is there a simple solution to this ?

You cannot run it unless you use a virtual machines such as Vmware with a less than 10Mb disk partition and a an old DOS. It can only be ran for geeky fun as it is impractical and the best solution would be upgrading to a current release compatible with the latest OS and 64bit.

You should be able to run it in a 64 bit system by using DOSBox

It is not trivial to run it on any emulator due to the graphics and hardware environment requirements of the old AutoCAD.

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been posted. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Your Information

(Name is required. Email address will not be displayed with the comment.)